Repairing a Loose Floor Tiles
During the useful life is a tile floor, tile and must resolve to repair. The degree of difficulty, this type of repair is about 3 on a scale of one to ten, with one of the simplest and ten more difficult. This type of repair is expensive, if awarded. Fall within the ability of owners of houses, and when the proper education, can easily be done in a weekend. Allow me a brief overview of how a slab detached from the bottom disk and Savealso a fee to an entrepreneur unnecessary work.
First, you need some simple tools, goggles, gloves, brooms, dust pan, or shop vacuum, hammer, chisel, masonry, piece of ribbon, knives, buckets, Malta, which will contain the original, which corresponds Malta sponge and a thin high quality. The candidate must be good for a change of character, which means that the additives in latex were mixed in it during manufacture. These additives can be set up to heal faster andhas a strong connection with the earth. It 'good to have a tile or two if you accidentally crack loose tiles during repair.
The most difficult part of the whole process is to get the loose stone from the ground. Even if the pieces do not remain connected to the plan no longer want, but still there. Discrepancies between the edges and joints must be removed against her. For your safetyLenses available, use a hammer and chisel and carefully remove the grout around tiles to lose. It 'important to use gentle downward strokes with a hammer. May not be the David of Michelangelo carving, but is still delicate. Be aware of and remove all the joints on all 4 sides of the tile loose. Malta must be removed completely before exposing the edges of the 4 adjacent tissues. When the mortar is removed, the tile should be easy to obtainhand. When this happens, gently lift the floor tiles with a chisel. Be sure to protect the edges of the plates are still good on earth.
Now that the brick was removed from the soil, remove the set from both thin tiles and the floor. With a hammer and chisel to remove the old thin from the back of the tile. Be careful with hammers on the tile. Place the tiles on a solid surface, such asa workbench, and take your time. A blow from a hammer and break your card. They have not been so careful to remove thin set from the underground. Remove them enough so the front of the mailboxes, when it returns to its original position below the surface level of about 3 / 16 of an inch.
With free boxes and the floor of the set the old thin, it is time to put the tiles into place. Mixingnew set of thin, carefully follow the manufacturer's specifications. The substance should be the consistency of peanut butter when they are properly mixed. It is easy to hold hands with them, if you touch it. Knives set Band, a thin, approximately the rear panel and the face of the substrate. If done correctly, you should do just fine the set, and the gap between the subfloor and tile, so that the surface of the tile to lie,same floor level. Also according to the manufacturer's instructions, so the set fine to treat. From my experience usually meet at night.
The last step is to grout around your tiles just presented again. As always, follow the instructions of the manufacturer recommends. With a knife, tape, fill the space between the tiles with grout and clean the excess grout with a sponge. The sponge should be damp but not wet. Novice TileSetter tend to a sponge, use too much water in it. Too much water can a sponge to remove a large amount of pigment from the municipality. The mortar is so good on a whitish color, the color does not match the existing collections. Mushroom Rank as hard as you can is good. An advanced technique is the new grout over the old spring. This makes it possible to mix the colors, and will not be so obvious.
Therefore, be diligent in cleaning the floor platesubstrate and the old thin set. Do your best to get the pieces back in the same layer of soil. Cement Mortar with care and the new spring on the grout malta old. If you follow these instructions to get the best of your ability, you have finished repairing the same if not better, each party has done for you.
Related posts: